Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Introduction) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all the fuel pipe and hose connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel system.
  2. Remove the fuel tank. Refer to Fuel Tank Replacement .
    3. Fig 1: Fuel Sender & Fuel Pressure Sensor Electrical Connectors
    GM863091Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear fuel feed pipe and the rear fuel return pipe from the fuel sender and the fuel tank clips.
  4. Cap the fuel pipes in order to prevent possible fuel system contamination.
scientia non olet · About Mike's Workshop Manuals