Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Regal LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Door System, Mirror System & Window System) >> Diagnostic Information and Procedures >> Power Mirror Select Switch Indicator Malfunction

Power Mirror Select Switch Indicator Malfunction

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Power Mirror Select Switch Indicator Malfunction

Step Action Yes No
Schematic Reference: Door Control Module Schematics 
Connector End View Reference: Power Door Systems Connector End Views 
1 Did you perform the Door Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Door Systems 
2 Verify that the power mirror select switch indicator malfunction fault is present.
Does the power mirror select switch indicator operate normally?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Is the power mirror select switch indicator always ON? Go to Step 4  Go to Step 5 
4
  1. Turn OFF the ignition.
  2. Disconnect the driver door module (DDM) C4 harness connector.
  3. Install a scan tool.
  4. Turn ON the ignition, with the engine OFF.
  5. Observe the Drv Mirror Select Led and Psgr Mirror Select Led parameters in the Left Door Control Module Inputs data list.
Does the scan tool display Inactive for both parameters?		 Go to Step 7  Go to Step 11 
5
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Observe the Drv Mirror Select Led and Psgr Mirror Select Led parameters in the Left Door Control Module Inputs data list.
Does the scan tool display Inactive for both parameters?		 Go to Step 11  Go to Step 6 
6 Are both of the power mirror select switch indicators inoperative? Go to Step 8  Go to Step 9 
7 Test the appropriate mirror select indicator control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 12 
8 Test the battery positive voltage circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 12 
9 Test the appropriate mirror select indicator control circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 10 
10 Test the appropriate mirror select switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 12 
11 Inspect for poor connections at the harness connector of the driver door module (DDM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 13 
12 Inspect for poor connections at the harness connector of the driver door switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 15  Go to Step 14 
13 Replace the driver door module. Refer to Door Control Module Replacement .
Did you complete the replacement?		 Go to Step 15  -
14 Replace the driver door switch. Refer to Front Door Switch Replacement .
Did you complete the replacement?		 Go to Step 15  -
15 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About Mike's Workshop Manuals