Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Rainier 5.3 P, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting/Connecting IAT Sensor Electrical Connector
    GM732048Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor electrical connector.
  2. Remove the IAT sensor (1) from the air duct with a twisting and pulling motion.
scientia non olet · About Mike's Workshop Manuals