Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Rainier 5.3 P, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
    Fig 1: Removing/Installing MAP Sensor
    GM825838Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1). Push the MAP sensor down in order to engage the sensor into the retainer.
    2. Fig 2: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  2. Connect the MAP sensor electrical connector (3).
scientia non olet · About Mike's Workshop Manuals