Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) - 3.8L (L36 And L67) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of FTP Sensor
    GM18839Courtesy of GENERAL MOTORS CORP.
  1. Install the FTP sensor.
  2. Connect the FTP sensor electrical connector.
    3. Fig 2: View Of Fuel Sender Access Panel & Bolts
    GM32756Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel sender access panel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fuel sender access panel bolts.

    Tighten:  Tighten the fuel sender access panel bolts to 2 N.m (18 lb in).

  5. Install the rear compartment floor trim.
scientia non olet · About Mike's Workshop Manuals