Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Seat Belt Retractor Replacement - Right Front >> Installation Procedure

Installation Procedure

  1. Install the seat belt retractor into the T-slot in the center pillar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Identifying Seat Belt Anchor Plate Nut
    GM370568Courtesy of GENERAL MOTORS CORP.
  2. Install the retractor side seat belt bolt.

    Tighten:  Tighten the retractor side belt bolt to 68 N.m (50 lb ft).

    3. Fig 2: Locating Intermediate Guide Bolts
    GM371847Courtesy of GENERAL MOTORS CORP.
  3. Install the intermediate guide bolts.

    Tighten:  Tighten the intermediate guide bolts to 10 N.m (89 lb in).

    4. Fig 3: View Of Seat Belt Mounting
    GM370563Courtesy of GENERAL MOTORS CORP.
  4. Position the anchor plate to the seat stud.
  5. Install the anchor plate nut to the seat stud.

    Tighten:  Tighten the anchor plate nut to 42 N.m (31 lb ft).

  6. Install the lower center pillar trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
    7. Fig 4: View Of Seat Belt Guide Loop
    GM157282Courtesy of GENERAL MOTORS CORP.
  7. Position the guide loop to the guide adjuster bracket.
  8. Install the guide loop nut.

    Tighten:  Tighten the guide loop nut to 42 N.m (31 lb ft).

  9. Close the guide loop cover.
scientia non olet · About Mike's Workshop Manuals