Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Intake Air Temperature Sensor Components
    GM760425Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor electrical connector.
  2. Remove the IAT sensor (3) with a twisting and pulling motion.