Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls 3.8L (Introduction, Service & Replacement)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the camshaft position sensor to the engine front cover.
    2. Fig 1: View Of Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the camshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the electrical connector (2) to the camshaft position sensor (1).
  4. Install the drive belt. Refer to Drive Belt Replacement (L36) or Drive Belt Replacement (L67) in Engine Mechanical-3.8L.
  5. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
scientia non olet · About Mike's Workshop Manuals