Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Power Seat System) >> Repair Instructions >> Heated Seat Control Module Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the fasteners securing the seat cushion to the adjuster track. Refer to SEAT CUSHION REPLACEMENT - FRONT .
  3. Lift the front of the seat cushion up in order to gain access to the heated seat module (1).
    Fig 1: Gaining Access To Heated Seat Module
    G01743948Courtesy of GENERAL MOTORS CORP.
    CAUTION: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
  4. Disconnect the electrical connectors (3) from the heated seat module.
    5. Fig 2: Disconnecting Heated Seat Module Electrical Connectors
    G01743949Courtesy of GENERAL MOTORS CORP.
  5. Remove the fasteners (1) securing the heated seat module to the bottom of the seat cushion.
  6. Remove the heated seat module (2) from the bottom of the seat cushion.
scientia non olet · About Mike's Workshop Manuals