Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Antilock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Yaw Rate Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Yaw Rate Sensor Mounting Nuts, Yaw Rate Sensor & Yaw Rate Electrical Connector
    GM492697Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the rear compartment front trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  3. Remove the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
  4. Remove the 2 yaw rate sensor mounting nuts (1).
  5. Remove the yaw rate sensor (2).
  6. Disconnect the yaw rate sensor electrical connector (3).
scientia non olet · About Mike's Workshop Manuals