Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Battery

Courtesy of GENERAL MOTORS CORP.

Install the battery.
Install the battery retainer and bolt.
Tighten: Tighten the battery retainer bolt to 17 N.m (13 lb ft).

Fig 2: View of Battery Vent Tube

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure the vent tube (1) is properly routed through the floor pan grommet.

Install the battery vent tube (1) to the battery.

Fig 3: Disconnecting Positive Battery Cable

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive cable (1) to the battery.
Tighten: Tighten the battery cable bolt to 17 N.m (13 lb ft).
Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .