Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Wiper System And Washer System) >> Repair Instructions >> Windshield Outside Moisture Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rain Sensor Module
    GM746991Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the rain sensor module.
  2. Install the rain sensor module in the windshield coupler.
  3. Fasten the windshield coupler clips.
    4. Fig 2: Removing/Installing Windshield Outside Moisture Sensor Cover
    GM746989Courtesy of GENERAL MOTORS CORP.
  4. Install the trim cover on the rain sensor module.
scientia non olet · About Mike's Workshop Manuals