Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Seat System) >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the memory seat module to the bottom of the seat cushion.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the memory seat module fasteners.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

    3. Fig 1: View of Memory Seat Module
    GM295290Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connectors to the memory seat module.
  4. Ensure the wiring harness is positioned in the original location.
  5. Install the seat cushion. Refer to Seat Cushion Replacement - Front .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 in SIR.
  7. Calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About Mike's Workshop Manuals