Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2000 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Seat System) >> Repair Instructions >> Heated Seat Control Module Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Electrical Connectors, Fasteners & Heated Seat Module
    GM430383Courtesy of GENERAL MOTORS CORP.
  1. Position the heated seat module (2) to the bottom of the seat cushion.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the heated seat module fasteners.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

  3. Install the electrical connectors (3) to the heated seat module (2).
  4. Ensure the wiring harness is positioned in the same location in which it was removed.
  5. Install the seat cushion. Refer to Seat Cushion Replacement - Front .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About Mike's Workshop Manuals