Without Driver Information Center
NOTE:
Programming must be done through Driver Information Center (DIC) if equipped.
- Close all doors. Turn ignition on. Ensure doors are kept closed throughout the entire process.
- Press and hold driver's power door lock switch in LOCK position. Press LOCK button on RKE transmitter. The automatic door locks will remain in current mode.
- Press LOCK button on RKE transmitter again. Each time transmitter's LOCK button is pressed, mode will advance by one, going from Mode 5 to Mode 0 to Mode 1, etc. Door locks will cycle according to mode entered to verify mode. Mode 0 has no feedback. See AUTOMATIC DOOR LOCK MODES table.
- When desired mode setting is reached, release door lock switch and turn ignition off. Automatic door lock operation will remain in the most recent mode selected.
AUTOMATIC DOOR LOCK MODES
| Mode | Shift Out OF Park Lock | Ignition Off Unlock | Shift Into Park Unlock |
|---|---|---|---|
| 0 | No | No | No |
| 1 | Yes | No | No |
| 2 | Yes | No | Driver Door Only |
| 3 | Yes | No | Yes |
| 4 | Yes | Driver Door Only | No |
| 5 | Yes | Yes | No |