Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installation Intake Air Duct

Courtesy of GENERAL MOTORS CORP.

Install the intake duct on the throttle body.
Rotate the intake duct down and install the intake air duct onto the air cleaner.
Tighten: Tighten the intake duct clamp to 2 N.m (18 lb in).

Fig 2: View of Intake Air Temperature Sensor and Electrical Sensors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the intake air temperature (IAT) sensor (1).