Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 1990 >> LeSabre Base, 4T60/ME9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.8L PFI >> Diagnostic Code Charts: 13 - 65 >> Code 15: Coolant Temp Sensor Signal Volt High >> Notes

Code 15: Coolant Temp Sensor Signal Volt High: Notes

At operating temperature, voltage will measure about 1-2 volts at ECM terminal.

NOTE: Test numbers refer to test numbers on diagnostic chart. The "Scan" tester reads engine temperature in degrees centigrade.
  1. Code 15 will set if the monitored voltage indicates a coolant temperature less than -36°F (-38°C) for at least 4 seconds with engine running.
  2. This test simulates a Code 14. If the ECM recognizes the low signal voltage (high temperature) and "Scan" tester reads 140°C, the ECM and wiring are okay.
  3. This test determines if circuit No. 410 is open. Using a digital volt-ohmmeter, there should be 5 volts present at sensor connector. If Code 15 is set, the ECM uses a default coolant value of about 120°F (49°C). However, the "Scan" tester will read the actual temperature indicated by the sensor.
scientia non olet · About Mike's Workshop Manuals