13 62 594 Removing And Installing/Replacing Pressure Sensor On Right Intake Manifold (N63)

Necessary preliminary tasks: 

• Read out fault memory of DME control unit.
• Switch off ignition
• Remove front right WHEEL ARCH COVER (FRONT SECTION) .

Unlock plug (1) and remove.

Release screws (2).

Tightening torque, see 13 62 2AZ in SENSOR FOR CONTROL UNIT .

Pull pressure sensor (3) out of left intake manifold.

Fig 1: Pulling Pressure Sensor From Left Intake Manifold

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Now clear the fault memory.