52 26... Removing and installing outer fold trim

Necessary preliminary tasks

Remover INNER FOLD TRIM .
Remove outer FOLLOWER TRIM .

Trim, fold, outer (pivot bearing):

Release screw (2).

Tightening torque: 52 26 25AZ .

Pull off release handle (1).

Fig 1: Pulling Off Release Handle

G08529834

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Fig 2: Locating Seat Backrest Frame

G08529835

Courtesy of BMW OF NORTH AMERICA, INC.

Only for seat backrest frame, left (60 %):

Push on locking clip (1).

Pull off ball socket.

Fig 3: Pushing On Locking Clip

G08529836

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Gas-filled strut (1) is under tension.

Lever ball socket with screwdriver on pin.

Fig 4: Removing Ball Socket Using Screwdriver

G08529837

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 52 26 27AZ .

Fig 5: Identifying Seat Backrest Frame Screw

G08529838

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully tighten follower (2) on seat cushion frame.

Feed trim (1) out of seat mechanism.

Fig 6: Feeding Trim Out Of Seat Mechanism

G08529839

Courtesy of BMW OF NORTH AMERICA, INC.