Information on Check Control messages
The following warnings and their causes can appear as Check Control messages in the CID:
Message: Dynamic Drive failed or disabled!
With the warnings:
- Dynamic Drive failure!
- Dynamic Drive disabled!
the Dynamic Drive system has been switched off.
NB: the vehicle tilts more strongly in bends than a vehicle without the Dynamic Drive System. Precondition for continued driving to the next workshop:
- Lower cornering speed
- No significant oil loss.
Possible causes of the warning message:
- Defect on the front axle pressure sensor
- Defect in the pressure build-up (pump)
- Defect in at least one active stabilizer bar
- Fault in the ARS control module A148
In order to be able to pinpoint the cause more exactly, read the fault memory and run through the displayed test plan. When the fault has been remedied, clear the fault memory.
Message: Steering!
With the warning:
- Steering!
the driver is informed that the vehicle has suffered oil loss in the chassis and steering system.
In this case, it is not possible to continue driving to the next workshop.
Possible causes of the warning message:
In order to be able to pinpoint the cause more exactly, read the fault memory and run through the displayed test plan. When the fault has been remedied, clear the fault memory.
Message: Dynamic Drive disrupted!
With the warning:
- Dynamic Drive disrupted!
the driver is notified that the chassis stabilization from Dynamic Drive is restricted, but it is possible to continue driving.
A workshop should be contacted at the next opportunity.
Possible causes of the warning message:
- Defective CAN message (driving speed)
- Defective lateral-acceleration sensor
- Fault in the rear-axle circuit
- Fault during the Predrive Check
In order to be able to pinpoint the cause more exactly, read the fault memory and run through the displayed test plan. When the fault has been remedied, clear the fault memory.
No liability can be accepted for printing or other faults. Subject to changes of a technical nature