52 26... Removing and installing outer fold trim

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove INNER FOLD TRIM
Remove outer FOLLOWER TRIM

Trim, fold, outer (pivot bearing):

Release screw (2).

Tightening torque: 52 26 25AZ .

Pull off release handle (1).

Fig 1: Pulling Outer Fold Trim Release Handle

G08529834

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Fig 2: Locating Outer Fold Trim Release Handle Screws

G08529835

Courtesy of BMW OF NORTH AMERICA, INC.

Only for seat backrest frame, left (60 %):

Push on locking clip (1).

Pull off ball socket.

Fig 3: Pushing Outer Fold Trim Locking Clip

G08529836

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Gas-filled strut (1) is under tension.

Lever ball socket with screwdriver on pin.

Fig 4: Pressing Gas-Filled Strut

G08529837

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 52 26 27AZ .

Fig 5: Identifying Outer Fold Trim Screws

G08529838

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully tighten follower (2) on seat cushion frame.

Feed trim (1) out of seat mechanism.

Fig 6: Pulling Seat Mechanism Trim

G08529839

Courtesy of BMW OF NORTH AMERICA, INC.