Mike's Workshop Manuals: Service manuals for every vehicle
Home >> BMW >> 2012 >> M3 2D Convertible, Standard Trans >> Repair and Diagnosis >> General Information >> OEM General Information >> Mobile Service -- M3 Convertible >> Initialization Procedures >> Initialize Run Flat Indicator >> BMW Group Mobile Service

BMW Group Mobile Service

E90, E91, E92, E93 

G09895025
There is a puncture when the vehicle symbol and yellow indicator light both light up. Depending on the tire damage, it is possible to continue the journey with run-flat tires at speeds up to 80 km/h.
The maximum possible remaining distance of a faulty, depressurized run-flat tires, is 80 km with a medium vehicle load.
Run Flat Indicator initialization 
Initialization can only be carried out when the tire pressure is OK. It must be ensured that there is no puncture.
Do not initialize the system when snow chains are used!
G09895026
The tire pressure table is located on the door post with opened driver's door.
G09895027
Initialization by using the on-board computer equipment 
Start the engine but do not drive off.
Select the following steps from the main menu:
"Vehicle information"
"Vehicle status"
Start initialization with "Confirm tire pressure".
Initialization is completed during the journey.
G09895028
Initialization by using the drop arm 
Start the engine but do not drive off
Press button 1 up or down until the corresponding symbol and "Reset" appear
Press button 2 to confirm the selection.
G09895029
Press button 2 for 5 sec until a hook appears. Depending on the software version, the "Active Reset" message may be displayed.
Initialization is completed during the journey.