61 35 127 Removing and installing/replacing body gateway module
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Read out PROGRAMMING/ENCODING .
- Print out and make a note of settings for Car&Key Memory in CKM menu
Necessary preliminary work:
- Disconnect NEGATIVE BATTERY CABLE
- Remove TRIM PANEL FOR PEDAL MECHANISM .
Disconnect plug connection (1).
Release screw (2) and remove cable shoe (4).
Tightening torque 61 35 3AZ .
Pull body module (3) out of equipment holder (5) in direction of arrow.
Installation note:
Make sure body module (3) is correctly installed in equipment holder (5).
Replacement:
Carry out PROGRAMMING/ENCODING .
Perform FlexRay synchronization via path:
- Body
- Central Gateway Module
- Initialize FlexRay
Check printed-out or noted-down settings for car and key memory in CKM menu and reset if necessary