67 62 ... Notes on initializing power window unit (from 04/2004)

WARNING: Danger of injury!
There is no anti-trapping protection during initialization.

NOTE: Cars built prior and up to 04/2004 have no anti-trapping protection and on the passenger side no toll closing function.

Initialization is performed on the power window switch of the relevant door.

Requirements for correct initialization:

Initialization comprises:

An initialization must be performed:

In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
After the power window drive has been replaced
After work is carried out on the power window mechanism
After a power supply interruption, e.g. disconnection of the battery or disconnection of the power supply to the door
After the door window glass has been removed and installed or replaced
After adjustment work on the door window glass
After adjustment work on the convertible top
After replacement of seals

Erasure of initialization:

This erases initialization of the power window, anti-trapping protection and toll function are inactive.

Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Reinitialization:

Avoid a break between the two steps!

Open door window glass fully
Operate and hold power window switch in "Close" position (second switch stage)
Once the upper end position has been reached, hold power window switch in "Close" position for approx. 2 seconds longer
Open door window glass fully
Operate and hold power window switch in "Close" position (second switch stage)
Once the upper end position has been reached, hold power window switch in "Close" position for approx. 2 seconds longer

This completes initialization.

NOTE: Carry out function check (one-touch control function, anti - trapping protection and, if necessary, comfort function).