ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING: Installing

Install in the reverse order of removal while noting the following:

New Hydraulic Control Unit:

Fig 1: Identifying The Control Module Removable Bolt And Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Attach the bracket -1- with the bolt -arrow-.

-- Carefully press the hydraulic control unit -2- in the pins -arrows- on the bracket -1-.

Fig 2: Identifying ABS Control Module with ABS Hydraulic Unit Removal

Courtesy of AUDI OF AMERICA, LLC

-- Insert the brake lines -1 and 2- into the ABS Hydraulic Unit -N55- and then install the union bolts by hand and tighten.

Fig 3: Hand Tightening Union Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -3-.

-- After securing the brake lines to the hydraulic unit select the "Hydraulic connections, basic setting" program. Refer to DIAGNOSTIC ENTRIES .

-- Follow the instructions in the Vehicle Diagnostic Tester display.

-- Remove the Brake Pedal Actuator:V.A.G 1869/2 .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Complete the "Control module, replacing" program after replacing the hydraulic control unit using the Vehicle Diagnostic Tool.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.