Protective Window, Removing

WARNING: This page is about a different car, the 2023 Audi S6 and 2023 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The Night Vision System Camera -R212- is removed

NOTE:

If the protective window is no longer water tight due to damage, the Night Vision System Camera -R212- must be completely replaced. Refer to Night Vision System Camera -R212-, REMOVING AND INSTALLING .

-- Remove the trim OVERVIEW - NIGHT VISION SYSTEM CAMERA.

-- Push the retaining tabs -arrows- together and turn the cover approximately 90° counter-clockwise.

Fig 1: Turning Cover Approximately 90 Degrees Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cover, protective window and seal from the Night Vision System Camera -R212-.

Replace the seal after every removal.

Installing

Install in the reverse order of removal while noting the following:

-- Calibrate the Night Vision System Camera -R212-. Refer to INFRARED SYSTEM, CALIBRATING .

Tightening Specifications

Refer to OVERVIEW - NIGHT VISION SYSTEM CAMERA