Night Vision System Camera -R212-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi SQ8, 2022 Audi RS Q8, 2022 Audi Q8, 2021 Audi SQ8, and 2021 Audi RS Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Remove the upper air guide. Refer to OVERVIEW - RADIATOR/RADIATOR FAN .

-- Release the clamp -arrow- and remove the washer fluid hose -1-.

Fig 1: Removing Washer Fluid Hose

Courtesy of AUDI OF AMERICA, LLC

-- If necessary seal the washer fluid hose.

-- Remove the screws -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- with the retaining plate -1- from the radiator grille and guide it out upward. Pay attention that the spray nozzle is not damaged.

-- Release and disconnect the connector -2- from the Night Vision System Camera -R212-.

-- Remove the screws -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Camera -R212- -1- from the retaining plate -2-.