Drivetrain Control Module - J775-, REMOVING AND INSTALLING, AUDI Q8: Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi SQ8, 2022 Audi RS Q8, 2022 Audi Q8, 2021 Audi SQ8, and 2021 Audi RS Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- After installing a new Drivetrain Control Module -J775- activate the control module.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-Capable Systems
- 0074 - Suspension control J775
- 0074 - Suspension control functions
- 0074 - Replace control module
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Readapt the standard vehicle height. Refer to STANDARD VEHICLE HEIGHT, READAPTING .