Lane Change Assistance Control Module -J769- / -J770-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Component location. Refer to COMPONENT LOCATION OVERVIEW - SENSORS AND CONTROL MODULES IN REAR SECTION OF VEHICLE .
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -4-.
-- Release the catch -1- and tilt the control module -2- out -arrow-.
-- Pry out and remove the control module from the lower mount -3- with the Trim Removal Wedge:3409 .