Rearview Camera -R189-, REMOVING AND INSTALLING
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
The Rearview Camera -R189- is integrated in the Release Button in Rear Lid Handle -E234-. The Rearview Camera -R189- and the Release Button in Rear Lid Handle - E234- cannot be separated. If damaged, the entire Release Button in Rear Lid Handle -E234- must be replaced with the rearview camera.
-- If replacing the control module, select the "Replace control module" function for the corresponding control module using the Vehicle Diagnostic Tester.
-- Remove and install the Release Button in Rear Lid Handle -E234-. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN LUGGAGE COMPARTMENT .
- After removing and installing the Rearview Camera -R189- the rearview camera system must be calibrated. Refer to REARVIEW CAMERA SYSTEM, CALIBRATING .