Night Vision System Control Module -J853-, REMOVING AND INSTALLING, THROUGH 11/6/2016: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Loosen the left front seat and, with the wires still attached, push it toward the rear. Refer to OVERVIEW - FRONT SEAT .
-- Remove the floor mat.
-- Disengage the carpet and push aside.
-- Remove the nuts -arrows- from the bracket -1-.
-- Release and disconnect the connectors -2- from the Night Vision System Control Module -J853-.
-- Remove the Night Vision System Control Module -J853- with the bracket -1-.
-- Remove the screws -3- and remove the Night Vision System Control Module -J853- -1- from the bracket -2-.