Engine Speed Sensor -G28-, Removing And Installing
WARNING: This page is about a different car, the 2021 Audi Q7 and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to the appropriate service information .
-- Disconnect the connector -2-.
-- Remove the bolt -1- and the Engine Speed Sensor -G28-.
Installing
Install in reverse order of removal and note the following:
- Replace the O-rings after removing them.
Tightening Specifications
- Refer to OVERVIEW - IGNITION SYSTEM
- Refer to the appropriate service information .