ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5, 2022 Audi A5 Quattro, 2021 Audi S5, and 2021 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

-- If necessary, install the hydraulic control unit bracket.

-- Insert the hydraulic control unit just far enough into the vehicle in order to connect the connector -3-.

-- Carefully push the hydraulic control unit -1- into the pins -arrows-.

Courtesy of AUDI OF AMERICA, LLC

The hydraulic control module must rest in all pins.

-- Remove the plug.

-- Insert the brake lines -1 and 2- into the ABS Hydraulic Unit -N55- and then install the union bolts by hand and tighten.

Courtesy of AUDI OF AMERICA, LLC

-- After securing the brake lines to the hydraulic unit, perform output diagnostic test mode using the Vehicle Diagnostic Tester.

TIP:

It can be determined in output diagnostic test mode, if the line connections were switched.

-- Remove the Brake Pedal Actuator :VAG1869/2 .

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- If the ABS Control Module -J104- /ABS Hydraulic Unit -N55- is being replaced, select the "Replace" function for the ABS Control Module -J104- /ABS Hydraulic Unit -N55- on the Vehicle Diagnostic Tester, Guided Functions .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.