Engine, Supporting In Installation Position
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Engine Support Bridge :10-222A
- Engine Support Bridge - Spindle :10-222A/11
- Engine Support - Supplement Kit :T40093A
Procedure
-- Install the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Place the :10-222A on the left and right side of the longitudinal member.
-- Engage the :10-222A/11 at the left and right on the engine lifting eyes.
-- Tension the engine with the spindles slightly until the engine mount is not under a load.
Assembling
Assemble in the reverse order of removal. Note the following:
-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .