Windshield Projection Head Up Display Control Module -J898-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5, 2022 Audi A5 Quattro, 2021 Audi S5, and 2021 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- A control module that has fallen down cannot be used again.

- When inserting the control module, never apply pressure on the housing upper section.

-- Insert the Windshield Projection Head Up Display Control Module -J898- and tighten the bolts.

-- Mount the windshield and secure it - do not bond it.

-- Turn on the ignition and check the Windshield Projection Head Up Display Control Module -J898- function.

A number must be visible on the windshield.

-- Calibrate the Windshield Projection Head Up Display Control Module -J898-. Refer to Windshield Projection Head Up Display Control Module -J898-, CALIBRATING .