Clip on Distance Regulation Control Module - J428-, Replacing: Procedure
- Distance Regulation Control Module - J428- removed from the retaining plate.
TIP:
The clips cannot be removed without being damaged.
- Place a screwdriver between the hook and the housing.
- Bend every hook all the way around with the screwdriver until it audibly breaks off.
- To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.
- Insert the new clip into the hole in the housing as shown and then press on it by hand until it clicks into place.
- The tabs on the clip must sit correctly in the recesses.
- Mount and screw in the stud bolt.
- The stud bolt must be aligned correctly to the clip.
- Turn the stud bolt into the distance regulation control module up to the dimension -a-.
- Measure the dimension -a- at all stud bolts using the -VAS6335- and correct if necessary.
- Dimension -a- = 17.6 mm.