Transmission Fluid Level, Checking

Special tools and workshop equipment required

Torx Socket - T60 :T40087

Fig 1: Hex Ball Socket TORX TB 60 T40087
Courtesy of AUDI OF AMERICA, LLC
Protective Eyewear

Procedure

NOTE:

General repair instructions. Refer to the appropriate service information.

Guidelines for clean working conditions. Refer to the appropriate service information.

Do not exchange the transmission fluid (MTF) chamber with the ATF chamber.

Replace the plug for the inspection and fill hole.

Transmission fluid temperature at approximately 20 °C (68 °F) (room temperature).
Move vehicle onto a four-pillar workshop hoist or over a work pit so that it is absolutely horizontal.
The transmission must be still for at least 15 minutes to make sure the oil settles internally.

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Equipped on some models: remove the bolts -arrows- and nut -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the end panel -1- for the crossbrace.

WARNING:

Danger of eye injury.

-- Remove the plug -arrow- for the right inspection and fill hole on the transmission housing with the Torx Socket - T60 :T40087 .

Courtesy of AUDI OF AMERICA, LLC

The manual transmission fluid (MTF) must be 2 mm from the lower edge of the inspection and fill hole.

-- If the oil level is not correct, fill the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

Tightening Specifications