Calibration System:VAS721001, INSTALLING AND ALIGNING: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration System:VAS721001
- Vehicle Diagnostic Tester
After performing service work on the vehicle, it may be necessary to calibrate the peripheral camera system. In detail, this is the case after:
- Replacing one or more cameras
- Peripheral Camera Control Module -J928- replacement
- Flash the software from the Peripheral Camera Control Module -J928-
- Record the data set on the Peripheral Camera Control Module -J928-
- Repair work on components in which a camera is installed or that influence the component location of the camera
- Wheel Alignments
- When adjusting the overlap range of the individual cameras
- The standing height of one axle changes by more than 5 mm
- The standing height of the entire vehicle changes by more than 10 mm