Transmission Fluid Pan, Removing And Installing: Installing

Install in reverse order of removal. At the same time note the following:

• Replace the oil pan, seal, oil pan bolts and clamp after removal.
• If the DSG Transmission Mechatronic -J743- is being replaced, the O-ring is included in the replacement part delivery package.

-- Clean the sealing surface on the transmission housing of oil and grease.

-- Coat the O-ring on the DSG Transmission Mechatronic -J743- connector with gear oil.

-- Position the new oil pan -2- and tighten the new bolts -1- diagonally in multiple steps.

Courtesy of AUDI OF AMERICA, LLC

• When positioning oil pan, ensure electrical wires are not pinched.

-- Install the new clamp -3-.

• The offset side of the clamp points to the transmission.

-- Attach and lock the mechatronic connector on the transmission.

-- Install the air duct pipes and air duct hoses. Refer to OVERVIEW - CHARGE AIR SYSTEM .

-- Fill with transmission fluid (refer to TRANSMISSION FLUID, DRAINING AND FILLING ) and check the transmission fluid level (refer to TRANSMISSION FLUID LEVEL, CHECKING ).