Retaining Plate for Distance Regulation Control Modules -J428-/-J850-, Removing and Installing: Installing

Install in the reverse order of removal while noting the following: 

• Insert the new clips until they engage in the retaining plate.
• Left side of the vehicle: The closed clip -1- must be seated on the bracket -2- below on the inside.
• Right side of the vehicle: The closed clip -1- must be seated on the bracket -2- below on the outside.

  Courtesy of AUDI OF AMERICA, LLC

  Courtesy of AUDI OF AMERICA, LLC

  Courtesy of AUDI OF AMERICA, LLC

• Measure the dimension -a- at all stud bolts using the Digital Caliper - VAS6335- and correct if necessary.
  • Dimension -a- = 17.6 mm.
• Install the retaining plate with the stud bolts on the control module.
  • The stud bolt must be aligned correctly to the clip.
• Push the stud bolt -1- all the way in the clip -2- as shown.

  Courtesy of AUDI OF AMERICA, LLC

  Courtesy of AUDI OF AMERICA, LLC