Button In Handle, Moving Into Installation Position

Special tools and workshop equipment required 

• Locking Button Removal Tool:T40203 

Procedure 

Courtesy of AUDI OF AMERICA, LLC

• The locking button -2- projects out of its installation position on the selector lever handle.
• If the locking button was pressed in, it must be brought back to its installation position so that the selector lever handle can be installed.

-- Carefully guide the :T40203  all the way into the selector lever handle -1- in direction of -arrow-.

Fig 1: Carefully Install T40203 All The Way Into Handle -1-

Courtesy of AUDI OF AMERICA, LLC

• For reasons of clarity, the selector lever handle is shown without the selector lever boot. The selector lever boot cannot be removed from the handle.
• The opening on the :T40203  faces the locking button and the hook to the left.

-- Hold the selector lever handle -A- firmly and turn the :T40203  180° in direction of -arrow 1-.

Fig 2: Hold Handle -A- And Turn T140203 180 Degrees In Direction Of -Arrow 1-

Courtesy of AUDI OF AMERICA, LLC

-- Hold the selector lever handle firmly and carefully remove the :T40203  in direction of -arrow 2-.

• When removing the :T40203  , the locking button on the selector lever handle -A - is pushed out and locked.
  Fig 3: Resetting Lock Button With Tool T140203

  Courtesy of AUDI OF AMERICA, LLC
• Do not touch the locking button anymore before installing the selector lever handle so that the locking button does not fall back in.