Left Peripheral Camera - R244-/Right Peripheral Camera - R245-, Calibrating: Notes

Special tools and workshop equipment required

The Left Peripheral Camera - R244-/Right Peripheral Camera -R245- are installed inside the left and right exterior mirrors.

The following describes calibrating the Left Peripheral Camera -R244-. Calibrating the Right Peripheral Camera - R245- is identical.

Establish the requirements. Refer to Peripheral Camera System, Calibrating .
Install and align the -VAS6350A- with - VAS6350A/6-. Refer to Calibration Tool VAS6350A with Peripheral Camera Calibration. .
Connect the Vehicle Diagnostic Tester.

Setting Up the Calibration Device

-VAS6350/1- installing:

Check the dimension of the holes.
Equip the -VAS6350/1- appropriately. Use spacer pieces.
To do so, secure the three wheel bolt adapters in the hole circle to each -VAS6350/1-.
Place the paddle on both -VAS6350/1- and secure them using a clamping screw.
Place the -VAS6350/1- onto the wheel bolts on the front wheels.

The -VAS6350/1- are positioned by the "O-rings" in the adapters and secured.

NOTE: Attach the -VAS6350/1- onto the wheels so that any installed "anti-theft" wheel bolts are not connected to the - VAS6350/1-.

Courtesy of AUDI OF AMERICA, LLC

Position the equipped -VAS6350A- with the -VAS6350A/6- -4- near the vehicle.
Adjust the paddle -2- with a clamping screw so that it moves freely and easily just over the -VAS6350A- -4- calibration platform.