Distance Regulation Control Module -J428- Retaining Plate, Removing And Installing, Version 1: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Note the following:

NOTE:

Replace the quick release.

The stud bolts in the bracket are pre-set. If necessary, correct the setting.

If the stud bolts were removed, then the clips on the distance regulation control module must be replaced. Refer to CLIP ON Distance Regulation Control Module -J428-, REPLACING, VERSION 1 .

-- Place the control module on a soft and clean surface.

-- Measure the dimension -a- at all stud bolts using the :VAS6335 and correct if necessary.

Fig 1: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 44.3 mm.

-- Position the retaining plate -3- onto the distance regulation control module -1-.

Fig 2: Distance Regulation Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Carefully press the new quick release -4- onto the stud bolt -2-.

-- Turn the quick release clockwise onto the retaining plate to the stop in direction of -arrow-.