Distance Regulation Control Module -J428- Adapter Frame, Replacing, Version 2 Through My 2016: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the quick release.

The stud bolts in the adapter frame are pre-set. If necessary, correct the setting.

-- Place the control module on a soft and clean surface.

Courtesy of AUDI OF AMERICA, LLC

-- Measure the dimension -a- on all the stud bolts using the digital caliper and adjust them if necessary.

Adjust the dimension -a- on all stud bolts. Refer to Installing - Measure the dimension -a- at all stud bolts using the :VAS6335 and correct if necessary. .