Distance Regulation Control Module -J428- Adapter Frame, Replacing, Version 2 And RS3 From My 2017: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the quick release.

The stud bolts in the adapter frame are pre-set. If necessary, correct the setting.

-- Place the control module on a soft and clean surface.

Fig 1: Measuring Dimension --a-- With VAS6335

Courtesy of AUDI OF AMERICA, LLC

-- Measure the dimension -a- on the upper and lower stud bolt using a digital caliper and correct if necessary.

Different adjustment values dimension -a- for the upper and lower stud bolt.
Adjust the dimension -a- on the upper and lower stud bolt. Refer to Installing - Measure the dimension -a- at the upper stud bolt using the :VAS6335 and correct if necessary. .