Clip On Control Module For Adaptive Cruise Control -J428-, Replacing, RS3 Through My 2016

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the same distance regulation control module is reinstalled the clips on the distance regulation control module must be replaced.

The clips cannot be removed without being damaged.

Procedure

-- Remove the distance regulation control module retaining plate. Refer to BASEPLATE FOR Distance Regulation Control Module -J428-, REMOVING AND INSTALLING, RS3 THROUGH MY 2016 .

-- Remove the stud bolt -1- with a suitable tool -2-.

Fig 1: Identifying Stud Bolt Removal With Suitable Tool

Courtesy of AUDI OF AMERICA, LLC

-- Place a screwdriver between the hook and the housing.

Fig 2: Place A Screwdriver Between Hook And Housing

Courtesy of AUDI OF AMERICA, LLC

-- Bend every hook all the way around with the screwdriver until it audibly breaks off.

-- To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.

-- Insert the new clip into the hole in the housing from the left and then press on it by hand until it clicks into place.

Fig 3: Insert New Clip Into Hole For Housing From Left Side And Push It In By Hand Until It Audibly Engages

Courtesy of AUDI OF AMERICA, LLC

The tabs on the clip must sit correctly in the recesses.

-- Install the stud bolt.

The stud bolt must be parallel inside the hole and correctly aligned to the clip.

-- Turn the stud bolt into the distance regulation control module up to the dimension -a-.

Fig 4: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

-- Measure the dimension -a- on all the stud bolts using the digital caliper and adjust them if necessary.

Adjust the dimension -a- on all stud bolts. Refer to Installing - Measure the dimension -a- at all stud bolts using the digital caliper :VAS6335 and correct if necessary. .