Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Audi >> 2016 >> S8 Base >> Repair and Diagnosis >> Maintenance >> Procedures >> GENERAL INFORMATION (1 of 2) >> General Information >> Work Descriptions >> Windshield Washer Fluid, Checking Freeze Protection And Filling

Windshield Washer Fluid, Checking Freeze Protection And Filling

WARNING:

High Voltage System Warning Messages:

Working When the Ignition May Not Be On, refer to WORKING WHEN THE IGNITION MAY NOT BE ON .

Special tools and workshop equipment required 

   
NOTE:

Read the bright/ark boundary to obtain an accurate reading for the following tests.

-- Place a drop of water on the glass using a pipette. The bright/dark boundary can be clearly recognized on the "WATERLINE".

-- Check concentration of anti-freeze additive using refractometer:T10007 A  .

Scale -4- of refractometer applies to windshield cleanser concentrate:G 052 164  .

Fig 2: Identifying Refractometer T10007 Scales
GWWN02-0624Courtesy of AUDI OF AMERICA, LLC
   

Mixture ratio 

Freeze protection to Windshield washer fluid concentrate G 052 164 Water
1.4/ 0.4 F(-17/-18 °C) 1 part 3 part
-7.6/ 9.4 F (-22/-23 °C) 1 part 2 part
-34.6/ -36.4 F (-37/-38 °C) 1 part 1 part

Filling with fluid

NOTE:

Windshield washer fluid concentrate:G 052 164  protects the spray nozzles, the windshield washer fluid reservoir and the hoses from freezing.

All vehicles with fan type spray jets must be filled with windshield washer fluid concentrate:G 052 164  as this fluid has a low viscosity at minus temperatures. The complicated spray jet system could otherwise become blocked due to crystallized washer fluid that can affect the fan pattern of the spray jet. Windshield washer fluid concentrate:G 052 164  assures that the fan type spray nozzles remain functional even at low temperatures.

Fill with windshield washer fluid concentrate:G 052 164  in the warmer season also. The powerful cleanser removes wax and oil deposits from the windshield.

Freeze protection (anti-freeze) must be guaranteed to approximately -13°F (-25 °C) (approximately -31°F (-35 °C) in countries with an arctic climate) in the washer system.