6.2.5 Distance Regulation Control Module - J428- Retaining Plate, Removing And Installing, Version 3: Installing
Install in the reverse order of removal while paying attention to the following:
NOTE:
If the same distance regulation control module is reinstalled the clips on the distance regulation control module must be replaced. Refer to 6.2.8 Clip on Distance Regulation Control Module - J428-, Replacing, Version 3 .
.
- Install the retaining plate with the stud bolt on the control module.
- The stud bolt must be aligned correctly to the clip.
- Turn the stud bolt into the distance regulation control module up to the dimension -a-.
- Measure the dimension -a- at all stud bolts using the digital caliper -VAS6335- and correct if necessary.
- Dimension -a- = 41.8 mm.
- Pay attention that the shank -1- on the caliper when measuring the radar eye -2- does not contact it.