6.2.3 BASEPLATE For Distance Regulation Control Module - J428-, Removing And Installing, Version 2 Through My 2016: Installing
Install in the reverse order of removal. Note the following:
NOTE:
- Replace the quick release.
- The stud bolts in the adapter frame are pre-set. If necessary, correct the setting.
- Place the control module on a soft and clean surface.
- Measure the dimension -a- at all stud bolts using the - VAS6335- and correct if necessary.
- Dimension -a- = 40.3 ± 0.5 mm
- Position the retaining plate -3- onto the distance regulation control module -1-.
- Carefully press the new quick release -4- onto the stud bolt -2-.
- Turn the quick release clockwise onto the retaining plate to the stop -arrow-.