Perform any subsequent work using the Vehicle Diagnostic Tester.
- Connect the Vehicle Diagnostic Tester and proceed with a vehicle-specific entry in Guided Fault Finding.
Wait until the Vehicle Diagnostic Tester has checked all the vehicle control module.
- Press the GO TO button and select "function/component selection".
- Select the program in Guided Function.
Follow the instructions on the screen of the Vehicle Diagnostic Tester to perform the adjustment/calibration.
Turn the adjusting screw with a hex socket wrench (minimum length: approximately 120 mm) to mechanically adjust the Night Vision System Camera - R212- around its roller axle.
- To do so open the hood and remove the lock carrier cover Refer to Body Exterior Front Bumper Overview.
- Mount the hex socket wrench -2- and make the adjustment according to the specification in "Guided Fault Finding".
NOTE:
Make sure there is no one or nothing between the Night Vision System Camera - R212- and the infrared system calibration plate while making the adjustment.
Adjusting the pitch-yaw angle of the Night Vision System Camera - R212- is electronic by starting the correct program using the Vehicle Diagnostic Tester in Guided Function.